A large number of corporation can not gain profit from their products, the main reason lay on the unproper use of the sand maker, which lead to the machine break down and increase the production cost, because not only the halt of the machine, but also the cost for alter the spare parts can not be reduced.sometimes, the whole machine even be damaged, resulted in a huge loss in the profit. The following gives you a detailed information about the reasons leas to the break down of the machine.
First, keep in mind that the sand maker can not be forced to start when the material still be stocked in the machine body, when this happens, the motor will be damaged because the trigger pressure is over beyond the motor can hold, also some other parts will be damaged. So it is much more important to pay attention to the order to start the machines, and feed the rock material to the sand maker.
Second, any crushing machine get its own usage range, so is the sand maker. It requires the size of the rock material should not larger than a certain size, if it is over large, the material will blocked in the mouth of the machine. At this time, time will be wasted a lot because the material blocked in the mouth needed to be cleared and then the production bond to be influenced, what's worse, the impeller will be damaged by the rock material and the machine will restart only when the maintenance is keep going on.
Third, all the machine need the maintenance, however, the software mutual wearing will go deeper. Sand maker should be checked in a periodic time after a long time, which help prolong the machine life span.
Forth, the sand maker are all fastened to the base by the screw, but it will be loose through some time of employment. If the sand maker gave out the unusual nose, the machine should be check immediately and solved and fastened.
No comments:
Post a Comment